BPR6EIX NGKs iridium plug I run on the v6
Under 20 at a post office. Sent one away once for converting to a bias box
Shows perfectly fine one my phone with no watermarks... typical photobucket I guess..
Why use aluminium?? I would've used high tensile steel as a minimum.
I was actually going to make up a cardboard template before hand just to comfirm my own measurements. ;)
Top man thankyou
Measured the Bolts they look to be M12 x 80mm 1.75 tp on the outer caps and M12 x 93mm 1.75 tp on the inner caps. For anyone seeing this...
Thanks guys. I think I may go down the fabrication route. I can get the bolts no problem.
I know the rough size of the brace and from the picture...
One like this.
Does anyone have or know where I can source a crank brace in the uk? I have seen them in america but trying to get locally before I resort to...
Used this on mine when I relocated.
From an BMW E30 I Think and this for the fire wall.
Technically you should only be getting 12v when cranking the engine over as its like a jump start to the ballasted coil. whats the voltage across...
Used to be. Dont know if they are still running think they used to meet in east grinstead.
True but until you know the fault and trace it to the source. You are chasing your own ass.
Pull the plug on the cold start injector. You might be getting to much fuel when hot.
I would then lean on the roll bar being bent.
Measure the distance between the fire wall and the crossmember. Also just for shits and giggles measure the wing width from the door jam to the...
Alan is your man. But im not sure hes doing them anymore...
Separate names with a comma.